LT-0610K Intelligent Dimmer Rack

6 switched outputs at 10A
One10A MCB and one by pass switch for each channel
Applicable to distributed intelligent lighting control system
Compatible with LT-NET signal,DALI signal and DMX-512 signal
One group of 12V DC voltage output for control system
LED indications for three phase power supply
one LED for communication indication;
128 preset scenes
128 divided zone;
Fade time: 1～100s;
Applicable to control of energy-saving lamps, fluorescent lamp,and discharge lamp.


Product Characteristics
Control electronics: full digital, microprocessor controlled;
Ratings: rated for continuous duty: 6 x 2 kW;
Max. duty of LT-0610K 12 kW;
Operating environment: 0℃ to 40℃; relative humidity max. 90% at 25℃;
atmospheric pressure < 106kP.
Power supply system: 3NPE 400V 50Hz
TN-S system, neutral directly connected to earth,
230V between phase and neutral
Reduced-size N linear diameter is not allowed;
Single-phase operation is possible;
Supply voltage range: 230 V±10 %;
Rated supply current: Star system 3-phase 3N with PE supply:
20A per phase at 230V;Single-phase supply: 60A at 230V;
Controller protection: MCB mini breaker (Max. breaking capacity 6000A);
Control signal inputs: DMX and LT-NET(DALI)
signal can be switched over by nternal position selector switch;
DMX signal: correct DMX signal is continuous flash;
LT-NET(DALI) signal: correct LT-NET signal is red and green alternately;
DC supply for panels: 12V/0.2A;
Front panel indicators: power is OK or not for each channel (MCB trip);
DMX512 or LT-NET control signal is OK or not
LED indication for communication Power supply failure
LED indication for power supply
Dimmer test functions: When emergency button is pressed
internal switch can control the 6 channels;
By pass switch: when the function module go wrong
take the by pass switch on
Response time: DMX≤30ms;
Types of load: suitable for energy-saving lamps
fluorescent lamp and dis charge lamp
Electromagnetic compatibility standard: EN55103-1: 1996;
EN55103-2:1996;
Safety standard: EN60439 ,EN60950
Ingress Protection: IP2X


Protection:
Protection for each channel by MCB
(breaking capacity 6kA ) to ensure safe operation of system under rated conditions;
Power supply ingoing line diameter: 25mm2 for rigid wire, 16mm2 for stranded wire;
Load terminal outgoing line diameter: 6mm2 for rigid wire, 4mm2 for stranded wire;
Cables enter from the knockout cable hole at the top of the enclosure, or from the cable entry in the rear plate;
The terminal of control signal lines enter from the cable hole at the bottom.


Communication:
DMX512/1990 communication protocol;
LT-NET (DALI)interface protocol.


Cooling:
Convection cooling via the lateral aluminum heat sink;